Download Flash File,Firmware,Rom All Android Device

Monday, May 8, 2017

Samsung Galaxy Star 2 Duos SM-G130E Firmware

Samsung Galaxy Star 2 Duos SM-G130E Firmware
Samsung Galaxy Star 2 Duos SM-G130E Firmware

How to Install/Update Official Firmware on Samsung Galaxy Star 2 Duos SM-G130E via Samsung Kies:

Turn on Internet connection on your device (should have stable Internet connection)
Download and Install Samsung Kies Utility on your PC
Connect your device to PC through USB
Open/Run Samsung Kies, it should automatically detect your device
At the Samsung Kies home screen, you’ll see New Firmware Upgrade is available notification (If it show- “This is the last firmware”, then your device haven’t received the latest firmware on Kies, check back later or try flashing manually through Odin)
Click on the Firmware Upgrade button to start the update process
Follow onscreen instructions
Once done, your device will be reboot automatically
After reboot, you can disconnect your device from PC
If both the above official way don’t work for you, then download firmware from the below list and follow the manual installation guide as it is.

How to Update Samsung Galaxy Star 2 Duos SM-G130E Firmware Latest manually

1.First, enable USB debugging from the establishment.
2.DOWNLOAD official for the Samsung Galaxy Star 2 Duos SM-G130E  top and unzip it.
3. Download the latest version of Odin from above and unzip the zip file.
4 Run the file on your PC Odin3 v3.07 .exe.
5.Now boot your Galaxy Star 2 Duos SM-G130E download mode by press and holding the (Power + Home + Vol Down) buttons.
6.Once you enter download mode, is an ID: COM port turned blue and message added in Odin3 v3.07 .exe message box means that the device has been recognized by Odin.
If ID: COM does not appear, the driver is not installed correctly or try different USB cable.
7.Now locate and add the firmware file ‘tar’ (downloaded from above) to the tab / AP PDA in Odin.
8.Ensure that only these two options “Auto Reboot” and “Time F.Reset” is tick. (Make sure you re-partition is not marked)
9.Now click the “Start” button and start flashing the file. Waiting until ‘Pass’ appears in green on the Odin screen.
10 Done.


0 comments:

Post a Comment

hist

Popular Posts

Powered by Blogger.